Hercus 260 Lathe Enclosure Deflectors, may also work with the 10” South Bend, and Boxford lathes. If you enjoy operating a manual metal lathe, but you really don’t like metal swarf, and cutting fluid spewing onto the floor and you, a partial enclosure can reduce the problem.

G = geared head model (260 models only) The standard range of Hercus lathe is made in 3 basic models, A, B & C. With the exception of feed and thread .

1938 plymouth truck shop manual

  • Hercus 260: The verdict. If you want to turn your metal working passion into a money-making endeavor, then the Hercus 260 is the perfect investment that can help you jump start it up and bring it to places.

  • A specially prepared Operation & Parts Manual is available for the Hercus Lathe. Australian Hercus "Model 260" lathes - a late development of the original South .

  • Lathe will be re-painted in Hercus Vista Green, re-assembled and adjusted accordingly to Hercus Inspection Sheet Tolerances. (Copy available upon request) All replacement parts are genuine Australian Made by Hercus.

  • The Hercus lathe page. 98 likes. The Hercus Lathe page is for Hercus owners to share information and photos of their machines and projects and advertise.

  • Dec 19, 1980 2028-2, located in the back of this manual direct to: Commander, US Army use of the personnel to whom this lathe is issued. CE3L260.

ktm 250 mx 1984 manual

Phone: Website: 260 Metal Lathe Refurbishment. Has you .

  1. Turns out, Hercus made 15,000 nine inch lathes and 8,000 260(10 1/4") lathes so yours is getting towards the end of the run. The collets are 3C and Hercus made both a draw in collet attachment and a quick acting collet attachment.

  2. Hercus 260-AM Lathe Screwcutting Gearbox Plates 1967 Hercus A specially prepared Operation & Parts Manual · is available for the Hercus Lathe .

  3. Here is a Hercus 260 lathe I recently purchased from a school. It has a tapered roller bearing headstock with 1 1/16" spindle bore, 3/4hp motor.

Used Hercus compound idler gear bolt, bush, washer and nut suits 9" and 260 models.

creative soundworks sw320 manual meat

Thread: Scanned Lathe Manual for Hercus (SB clone). Hello Al,Your lathe sounds like it was made early to mid 1. Used cross slide gib strip for Hercus 260 or 9 inch metal lathe same part both models.